Dimension One Spas Bay Collection Manuale Utente

2004 Bay Collection 

Owner’s Manual 

 

 

 

 

 

 

 
The Heat Status Light will turn on when there is a call for heat and the heater 
engages. This is a normal function. The right side of the Digital Display Window 
will continue to read the current temperature while the bottom left corner will 
scroll the message “HEATING TO _ _ _° F”  until the hot tub reaches the set 
temperature. An animated thermometer will also be displayed in the upper 
center of the Digital Display Window to confirm heater activity. 
 
 

 

If the water reaches 2° F (≅1° C) above the set temperature, the message 
“COOLING TO _ _ _ - CIRC PUMP & O3 OFF” will be displayed in the 
bottom left hand side of the Digital Display Window and a cooling cycle will 
start. 

® 

 

 

 
The time of day can be viewed by pushing the Dimension One Spas ICON®- 
logo on the far right of the control panel. If no other button is pushed within 5 
seconds, the display will revert to the hot tub water temperature reading. The 
pre-set factory default is Fahrenheit. 
 
Pressing the logo for 5 seconds will place the spa in the “Standby” mode and 
allow the spa to be cleaned without turning off the power. 

 

 

 
The Top Side Control also offers a “built-in” infrared sensor. This infrared 
sensor allows the use of your optional D1 Remote Control to control the spa 
jets, fountain, interior lights, and iWatch perimeter lighting. 
 
To use it, simply point the D1 Remote Control at the infrared sensor and press 
the appropriate button on the remote control. The infrared sensor is the located 
between the Water Feature and Up buttons. 

28