Ariens 926316-ST1332DLET Manuale Utente

GB - 10

•

Pliers

•

Open-End Wrenches: 3/8, 7/16, 1/2, 
9/16 in. and/or Adjustable Wrench

•

Tire  Gauge

1. Remove the lower and loosen the upper 

wing knobs on the handlebar assembly.

2. Loosen the wing nuts on the shift rod.
3. Put the speed selector lever in the first 

forward position.

4. Rotate the handlebars into operating 

position.

5. Install and tighten all wing knobs and 

wing nuts on the handlebar assembly 
and shift rod.

NOTE: The handlebar has two height 
positions. Adjust the handlebar height to 
provide better operator comfort. See 
Handlebar Height on page 27.

(Figure 5)

1. Grease underside of discharge chute 

ring (if not already greased).

2. Remove mounting hardware from auger 

housing.

3. Install discharge chute over opening in 

the auger housing. Finger tighten the 
mounting hardware removed in step 2.

NOTE: Leave discharge chute pedestal loose 
to help install the chute rod and connect it to 
the control assembly.

WARNING: AVOID INJURY. Read 
and understand the entire Safety 
section before proceeding.

WARNING: Dropping or tipping 
over boxed unit could result in 
personal injury or damage to unit.

Figure 3

1. Sno-Thro 

Unit

2. Discharge 

Chute

3. Chute Rod

4. Literature 

Pack with 
Extra Shear 
Bolts

OS7020

1. Wing Knobs
2. Wing Nut
3. Bolt

4. Shift Rod
5. Speed 

Selector 
Lever

Figure 4 

OS7030