Ariens 926316-ST1332DLET Manuale Utente

GB - 12

NOTE: Press down on lock teeth with your 
finger to align the cable ball end with the slot 
(Figure 8). 

10. Replace the gear cover removed in 

step 4.

IMPORTANT: Rotate the discharge chute to 
the left when tightening the pedestal 
hardware to ensure clearance between the 
discharge chute and the belt cover.

11. Tighten pedestal hardware to 15 – 31 

lbf-ft (20 – 42 N•m).

12. Make sure the discharge chute rotates 

left and right when you push the 
discharge chute control lever left and 
right.

Connect the cable end to the cable anchor on 
the discharge deflector before clipping the 
cable to the cable bracket on the discharge 
chute.

1. Route deflector remote cable along the 

left side of the chute pedestal.

2. Insert the barrel on the cable end into 

the bracket on left side of chute deflector 
(Figure 9).

3. Hold seal out of the way while routing 

the cable through the bracket on the left 
side of the discharge chute, and then 
push the cable fitting into the bracket.

4. Push the seal securely over the end of 

the cable fitting to prevent water from 
entering the cable.

5. Check deflector travel. Adjust nut on 

cable end under handlebar to obtain full 
travel, if necessary. 

1. Remove wing nuts from battery cover.
2. Install wire lead to battery terminal.
3. Install battery cover and tighten wing 

nuts.

Without the engine running, press down 
(engage) both clutch levers. Release 
attachment clutch lever. Attachment clutch 
should remain engaged until traction clutch 
lever is released, then both clutches must 
disengage. If they do not, contact your Dealer 
for repairs.

Check tire pressure and adjust to the 
pressure listed on tire sidewall.

Figure 8

OS7271

Figure 9

1. Cable Anchor
2. Cable End
3. Deflector Cable
4. Cable Fitting
5. Cable Bracket

OS7070