Ariens 926316-ST1332DLET Manuale Utente
GB - 11
4. Remove the cover from the gear
assembly on the discharge chute.
5. Release the lock teeth on the gear
assembly with your finger and rotate the
discharge chute 90
°
left.
6. Remove and save the hairpin from the
control assembly underneath the control
panel.
panel.
NOTE: Do not remove the pin installed on the
chute rod.
NOTE: To ensure the discharge chute follows
its full range of travel, make sure the control
lever is pushed all the way to the left before
installing and pinning the chute rod.
chute rod.
NOTE: To ensure the discharge chute follows
its full range of travel, make sure the control
lever is pushed all the way to the left before
installing and pinning the chute rod.
7. Align the holes on the end of the chute
rod with the mark on the gear assembly
and slide the end without a pin through
the gear assembly, through the hook on
the chute lock cable and into the hex
hole in the control assembly.
and slide the end without a pin through
the gear assembly, through the hook on
the chute lock cable and into the hex
hole in the control assembly.
IMPORTANT: The hook will prevent the
control cable from contacting the engine or
muffler guard.
control cable from contacting the engine or
muffler guard.
NOTE: After the chute rod has been inserted
through the hex hole in the control assembly,
placing the unit in the service position (see
Service Position on page 23) will ease
alignment and installation of the hair pin.
through the hex hole in the control assembly,
placing the unit in the service position (see
Service Position on page 23) will ease
alignment and installation of the hair pin.
8. Secure the chute rod to the control
assembly with the hair pin removed in
step 6 using the end hole location as
shown in Figure 7. Insert the hair pin
with the loop end to the left of the chute
rod so the control assembly follows a full
range of travel.
step 6 using the end hole location as
shown in Figure 7. Insert the hair pin
with the loop end to the left of the chute
rod so the control assembly follows a full
range of travel.
9. Insert the chute lock cable fitting into the
bracket on the chute pedestal, and then
connect the chute lock cable to the lock
teeth by fitting the cable ball end into the
slot on the lock teeth. See Figure 8.
connect the chute lock cable to the lock
teeth by fitting the cable ball end into the
slot on the lock teeth. See Figure 8.
Figure 5
1. Mounting
Hardware
2. Discharge
Chute
3. Chute
Pedestal
4. Discharge
Chute Ring
OS7040
OS7045
Figure 6
1. Chute Rod
2. Gear Cover
3. Control Assembly
4. Hair Pin
2. Gear Cover
3. Control Assembly
4. Hair Pin
OS7060
Figure 7
1. Chute Control
Assembly
2. Hair Pin
3. Chute Rod
3. Chute Rod
OS7157