Avaya X330W2-DS1 Manuale Utente

Chapter 7

X330WAN CLI Commands

78

Avaya X330W-2DS1 User’s Guide

Use the

 ip rip default-route-mode command to enable learning of the 

default route received by the RIP protocol. The default state is talk-listen. Using the 
X330WAN, the no form of the command disables listening to default routes.

This command is executed from the Serial, Loopback, Fast Ethernet and 

Fabric Fast Ethernet interfaces.

The syntax for this command is:
[no] ip rip default-route-mode <mode>
The possible default route modes on an interface are:

Example:

X330WAN-2DS1-1(configure)#

 ip rip default-route-mode talk-only

Use the

 ip rip poison-reverse command to enable split-horizon with 

poison-reverse on an interface. The no form of this command disables the poison-
reverse mechanism.
The split-horizon technique prevents information about routes from exiting the 
router interface through which the information was received. This prevents routing 
loops.
Poison reverse updates explicitly indicate that a network or subnet is unreachable 
rather than implying they are not reachable. Poison reverse updates are sent to 
defeat large routing loops.

This command is executed from the Serial, Loopback, Fast Ethernet and 

Fabric Fast Ethernet interfaces.

The syntax for this command is:
[no] ip rip poison-reverse

talk-listen

Set RIP to send and receive default route updates on 
the interface.

talk-only

Set RIP to send but not receive default route updates 
on the interface.