Avaya X330W2-DS1 Manuale Utente

WAN CLI Commands

Avaya X330W-2DS1 User’s Guide

127

After setting the controller’s mode, this command will:

1.  Perform the copy running-config startup-config command.
2.  Erase startup-config.                                                                                                                           
3.  Reset the device.

The syntax for this command is:

[e1

|t1]

Output Example:

X330WAN-2DS1-1(configure)# ds-mode e1

Your startup-config file will be erased!

Your telnet session will be disconnected.

This operation may take a few minutes

The WAN module will reset, in order to make the required 

change.

Do you want to continue (Y/N)?

If this command is entered when the correct mode is selected (for example, 

entering ds1-mode e1 when the device is already in E1 mode) no errors are 
generated.

Use the duplex command to control the duplex setting for the interface.

The syntax for this command is:

 {full|half}

e1

Sets the device in E1 mode. All controllers are set to operate as E1.

t1

Sets the device in T1 mode. All controllers are set to operate as T1. 
This is the default.

full

 Full duplex

half

Halp duplex