Sanyo PLC-XU355K Manuale Utente

LASER button

PRESENTATION POINTER

button

This  remote  control  emits  a  laser  beam  from  the  laser  light  window.  Press  the  LASER  button  to  activate  the

laser pointer. The signal emission indicator lights red and the red laser beam is emitted. If the LASER button is

pressed for more than one minute or if it is released, the laser light goes off.

The laser emitted is a Class II laser. Do not look into the laser light window or point the laser beam at yourself or

other people. The following is the caution label for the laser beam.
CAUTION:

 Use of controls, adjustments or performance of procedures other than those specified herein may

result in hazardous radiation exposure. Never look directly into the laser light window while a laser

is emitted, otherwise eye damage may result.

The caution label is put on the remote control.

You can move the Spotlight or Pointer of the projector with the remote control to emphasize a part of the

projected image.

Press  and  hold  the  MENU  and  NO  SHOW  buttons  for

more  than  5  seconds  to  activate  the  Pointer  function.

(The Laser pointer has switched to the Pointer function.)

Press the LASER button on the remote control pointing

toward  the  projector.  The  Spotlight  or  Pointer  is

displayed on the screen with the LASER button lighting

green.  Then  move  the  Spotlight  or  Pointer  with  the

PRESENTATION POINTER button. If the LASER button

does not light green and continues to emit a laser beam,

try  the  abovementioned  procedure  until  the  LASER

button lights green.

To  clear  the  Spotlight  or  Pointer  out  the  screen,  press

the LASER button pointing toward the projector and see

if the LASER button lighting is turned off.

To switch to the Laser pointer again, press and hold the

NO SHOW and MENU buttons for more than 5 seconds

or slide the RESET/ON/ALL-OFF switch to RESET and

then to ON.

When you reset the Pointer function, the remote control

code will be reset, as well.



  You  can  choose  the  size  of  Spotlight  (Large/Middle/

Small)  and  the  pattern  of  Pointer  (Arrow/Finger/Dot)  in

the Setting Menu. See “Pointer” on page 52.

After  the  Laser  pointer  has

switched to the Pointer, use

the  LASER  button  as  the

Pointer  function  ON-OFF

switch.  Press  the  LASER

button  pointing  toward  the

projector  and  see  if  it  lights

green.

Laser Light Window

Signal Emission Indicator

MENU button
NO SHOW button
Press  and  hold  the  MENU

and  NO  SHOW  buttons  for

more than 5 seconds.

PRESENTATION POINTER

button