Sanyo PLC-XU355K Manuale Utente

To ensure safe operation, please observe the following precautions :

 ●  Use two (2) AAA or LR03 type alkaline batteries.

 ●  Always replace batteries in sets.

 ●  Do not use a new battery with a used battery.

 ●  Avoid contact with water or liquid.

 ●  Do not expose the remote control to moisture or heat.

 ●  Do not drop the remote control.

 ●  If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

 ●  Risk of an explosion if battery is replaced by an incorrect type.

 ●  Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Press the lid

downward and slide it.

Open the battery

compartment lid.

Install new batteries

into the compartment.

Replace the

compartment lid.

Two AAA size batteries
For correct polarity

(+ and –), be sure

battery terminals are

in contact with pins in

compartment.

Point  the  remote  control  toward  the  projector  (Infrared

Remote  Receiver)  when  pressing  the  buttons.  Maximum

operating  range  for  the  remote  control  is  about  16.4'(5  m)

and 60 degrees in front of the projector.

16.4'
(5 m)

30° Remote control

30°

Adjustable Feet

Feet Lock Latches

Projection angle can be adjusted up to 12.0 degrees with

the adjustable feet.

Lift the front of the projector and press the feet lock latches

on both side of the projector.

Release the feet lock latches to lock the adjustable feet and

rotate the adjustable feet to a proper height, and tilt.

Keystone  distortion  can  be  adjusted  automatically  with  the

Auto setup function or manually by using the remote control

or the menu operation (see pages 25, 47-48).