Lucent Technologies P332MF Manuale Utente
Chapter 4
Installation and Setup
Cajun
P332MF
User’s Guide
23
Configuring the Switch
The Cajun P330 may be configured using the text-based Command Line Interface
(CLI) utility, the built-in Cajun P330 Device Manager (Embedded Web) or
CajunView™.
(CLI) utility, the built-in Cajun P330 Device Manager (Embedded Web) or
CajunView™.
For instructions on the text-based utility, see the CLI chapter.
For instructions on installation of the graphical user interfaces, see the Cajun P330
Device Manager Appendix. For instructions on the use of the graphical user
interfaces, refer to the Manager User’s Guide on the Management CD.
Device Manager Appendix. For instructions on the use of the graphical user
interfaces, refer to the Manager User’s Guide on the Management CD.
Cajun P330 Default Settings
The default settings for the Cajun P330 switch and its ports are determined by the
Cajun P330 software. These default settings are subject to change in newer versions
of the Cajun P330 software. See the Release Notes for the most up-to-date settings.
Cajun P330 software. These default settings are subject to change in newer versions
of the Cajun P330 software. See the Release Notes for the most up-to-date settings.
Switch Settings
Table 4.1
Default Switch Settings
Function
Default Setting
Cajun P330 IP address
149.49.32.134
Default gateway
0.0.0.0
VLANs
VLAN 1
Spanning tree
Enabled
Bridge priority for Spanning Tree
32768
NTP server IP address
0.0.0.0
Timezone offset
0 hours
Read-only SNMP community string
Public
Read-write SNMP community string
Public
Trap SNMP community string
Public
SNMP retries number
3
SNMP timeout
2000 Seconds
SNMP authentication trap
Disabled
CLI timeout
15 Minutes