Inter-Tel CS-5200 Manuale Utente

Page  122

Endpoint Feature Codes

Do-Not-Disturb
Do-Not-Disturb Cancel
Do-Not-Disturb On/Off

370
371
372

The Do-Not-Disturb feature code halts all 
intercom calls, transferred calls, and pages to 
the endpoint. The Cancel code returns the 
endpoint to normal operation. The on/off code 
can be used to turn Do-Not-Disturb on or off. 
(Inter-Tel endpoints use the DND button.)

Do-Not-Disturb Override

373

(Not used on single line endpoints) If enabled 
in the database, allows the endpoint user to 
break through another endpoint’s Do-Not-Dis-
turb mode when placing an intercom call

Enhanced Speakerphone Enable

310

(Digital endpoints only) When entered at a 
digital phone, this feature code enables the 
enhanced speakerphone as described in “Dis-
play and Nondisplay Digital Phones’’ on 

. Digital endpoints can also use the 

Special button + Speaker buttons.

Feature Key Default

395

(Not used on single line endpoints) endpoints 
have user-programmable feature buttons that 
can be set to enter feature codes. This code 
returns the user-programmable buttons to the 
database default values.

Group Listen 

312

(Not used on single line endpoints) Allows a 
user to transmit a conversation over the end-
point speaker while in handset or headset 
mode

Handsfree On/Off

319

(Not used on single line endpoints) Disables/
enables the endpoint’s handsfree intercom 
answering. Incoming intercom calls ring as pri-
vate calls if handsfree answering is disabled.

Headset Enable
Headset Disable
Headset On/Off

315
316
317

(Not used on single line endpoints) The 
enable code signals the system that a headset 
has been connected to the endpoint. The dis-
able code returns the endpoint to normal oper-
ation. The on/off feature code can be used to 
toggle the feature on or off. 

Hold – Individual

336

Places a call on hold so that it can be picked 
up directly at that endpoint or through a 
reverse transfer from any other endpoint. 
(Inter-Tel endpoints use the HOLD button.)

Hold – System

335

Places an outside call on system hold. It can 
be picked up directly at any endpoint that has 
an individual trunk button and has allowed-
answer and/or outgoing access for that trunk, 
or by the endpoint that placed it on hold. (If 
used on conference or intercom calls, the sys-
tem places the call on individual hold.)

Hunt Group Remove
Hunt Group Replace
Hunt Group Remove/Replace

322
323
324

Removes the endpoint from its assigned hunt 
group(s) or places it in again. Does not affect 
non-hunt group calls. The remove/replace fea-
ture code can be used to toggle the feature.