Perle Systems 4030370 Manuale Utente
Hardware and Connectivity 48
Powering up your IOLAN
Disconnecting 48V Power Supplies from the IOLAN
To disconnect the power supply(s) from the IOLAN, do the following:
1.
Switch off the IOLAN.
2.
Switch off the power source(s).
3.
Disconnect all DC power input cables from the IOLAN terminal connector block.
4.
Remove any attached devices to the serial or Ethernet port(s).
Your IOLAN is ready to be moved.
Electric Utility Models
To power up the IOLAN, Electric Utility models, perform the following steps:
1.
Ensure that the power supply side of the connection is been powered down before
attempting to connect the wires on the IOLAN side.
attempting to connect the wires on the IOLAN side.
2.
Connect the power as outlined in the “wiring” section below which matches your model.
3.
Enable power to unit. Unit should now power up.Selecting Install Locations for LDC Models
Wiring
Safety warnings for ALL Electric Utility models
Safety warnings for HV and DHV models.
All equipment must be installed according to the applicable country wiring codes.
Grounding of HV and DHV models
The Electric Utility series of IOLAN units have a chassis ground screw. This connection must be
connected to "Equipment Ground" for DC installations or "Safety Ground" for AC installations. A
second “earth ground” connection is provided for secondary grounding. This should only be used in
conjunction with the grounding screw provided on the terminal connector.
The Electric Utility series of IOLAN units have a chassis ground screw. This connection must be
connected to "Equipment Ground" for DC installations or "Safety Ground" for AC installations. A
second “earth ground” connection is provided for secondary grounding. This should only be used in
conjunction with the grounding screw provided on the terminal connector.
Note:
The Electric Utility series of IOLAN units do not have a power switch, and an
appropriately rated circuit breaker must be installed externally to the unit. If two power
sources are used, each source must have a circuit breaker. As a safety precaution you
should not rely upon the unit's front panel LEDs as a power indicator.
Note:
WARNING
This unit should be installed in a restricted access location where access can only be
gained by service personnel or users who have been instructed about the reasons for the
restrictions applied to the location and about any precautions that shall be taken; and
access is through the use of a tool or lock and key, or other means of security, and is
controlled by the authority responsible for the location.
Note:
For your safety, before attempting to connect or modify any of the electrical connections
to the unit, please be sure all wiring is disconnected from any live power source. Power
should only be applied when you are sure that the wiring is correct and any safety covers
are properly installed.
to the unit, please be sure all wiring is disconnected from any live power source. Power
should only be applied when you are sure that the wiring is correct and any safety covers
are properly installed.