England's Stove Works 55-SHPEP Manuale Utente

Page | 38 
 

Auger Motor 

1.  Before beginning any component replacement, be certain the unit is unplugged and 

thoroughly cooled down.  Also, make sure the hopper is empty before attempting to 
remove or replace the auger motor assembly. 

2.  Remove the side panels and back panels as previously detailed in this manual on Page 32 

in the “Exhaust Blower Cleaning” section.  Before loosening any bolts, detach the wiring 
harness from the auger motor. 

3.  Locate the auger motor assembly at the rear of the stove, and begin by loosening the two 

allen set screws on either side of the cast iron auger motor coupler. 

4.  Slide the auger assembly out of the tube enough that the allen set screw, which holds the 

auger to the steel auger coupler, can be accessed.  Loosen this set screw until the auger is 
free from the auger motor assembly. 

5.  Next, remove the four screws which hold the cast iron auger motor coupler to the auger 

motor, using a 5/16” wrench.  Slide the cast iron auger motor coupler and the steel spacer 
plate off of the auger motor. 

6.  Loosen the allen set screw which holds the steel auger coupler to the auger motor output 

shaft, and remove the steel auger coupler, as well as the rubber vibration dampener. 

7.  Reinstall the parts in reverse order on the new auger motor, being careful not to over-

tighten the bolts which hold the cast iron auger coupler to the auger motor.