England's Stove Works 55-SHPEP Manuale Utente

Page | 40 
 

Vacuum Switch 

1.  Before beginning any component 

replacement, be certain the unit is 
unplugged and thoroughly cooled 
down.  

2.  Remove the right side panel and the 

back panel as previously detailed. 

3.  Locate the vacuum sensor as shown 

in the diagram below. 

4.  Disconnect the stove wiring harness 

and vacuum hose from the vacuum 
sensor, taking note of where 
connections were made. 

5.  Remove the two screws which hold 

the vacuum sensor to the vacuum 
sensor bracket, using a 5/16” 
wrench. 

6.  Installation is the reverse of removal; 

be absolutely certain the wires and 
vacuum hose are connected 
according to the wiring diagram in 
this manual. 

Igniter 

1.  Before beginning any component 

replacement, be certain the unit is 
unplugged and thoroughly cooled 
down.  

2.  Remove the right side panel and the 

back panel as previously detailed. 

3.  Locate the igniter as shown in the 

diagram below. 

4.  Disconnect the igniter wiring from 

the control board and use a 5/16” 
wrench to remove the igniter 
retaining screw. 

5.  Loosen the allen set screw and 

remove the old igniter cartridge. 

6.  Install the new igniter in the igniter 

tube, retighten the set screw and 
reinstall the assembly into the stove.  
Be certain to reconnect the new 
igniter wires to the circuit board 
before reassembly.