Desa CGCDV42NR Manuale Utente

www.desatech.com

116236-01E

26

4. Remount the new frame at the hinge with five

new screws before closing door. This will

ensure seating of the gasket.

5. Close glass door frame. Lock latches by placing

the bar under the tab on door and pushing down

and back on latch (see Figure 41, page 25).

6. Replace screen/rod assembly by reversing

step 1.

7. Replace louvers by reversing procedure

under Removing Louver Panels, page 25.

Cleaning Glass Door

See Cleaning and Maintenance on page 31.

INSTALLING LAVA ROCK AND
GLOWING EMBERS

It is very important to keep logs exactly as

installed. Do not modify logs. Only use log set

designed for this fireplace. Logs under log/grate

assembly are attached to burner. Do not attempt to

move these logs as this will damage logs.

WARNING: Logs are unitized

and attached to the grate. Do not

handle log/grate assembly by

logs. Always pick up by grate.

Open louvers, remove screen, unlock door latches

and open glass door. See Removing Glass Door,

steps 1 and 2, page 25.

1. Pull ember material apart into pieces no larger

than a dime. Place these pieces loosely and spar-

ingly directly onto the exposed front section of

the burner (see Figure 42). This will create

the glowing ember appearance as the flame

touches the ember material. Do not block air

slots by using too much ember material in one

area. It is not necessary to use all of the ember

material provided.

2. Pour lava rock onto plenum but not onto flat

burner. It is not necessary to use all of the lava

rock provided.

NOTICE: Do not put lava rock on

burner or under burner. Placing

lava rock on burner will cause

performance problems.

FIREPLACE

INSTALLATION

Continued

3. Close glass door, lock door latches, replace

screen and close louvers (see Removing Glass

Door, steps 5 through 7).

WARNING: The glass door

must be securely in place before

running this fireplace. Do not run

this fireplace if glass is missing

or broken.

Figure 42 - Placing Ember Material on

Burner

Embers

Plenum

INSTALLING BRICK LINER MODELS
BL42DA(SA) AND BL42DHA(SA)

WARNING: If fireplace has

been running, turn off unit. Let

cool before installing brick liner.

You may purchase brick liner from your local

retailer or see Accessories, page 42.

CAUTION: Always handle

brick panels with two hands.

Do not force brick panels into

place. Excessive force will break

brick panels.

1. Remove top and bottom louvers to allow ac-

cess to door latches.

2. Unlock door latches and open glass door. See

Removing Glass Door, steps 1 and 2, page 25.

3. Carefully remove lava rock and ember material.

Remove log/grate assembly by unscrewing grate

from plenum. The two logs under the grate are at-

tached to burner. DO NOT attempt to remove.

4. Remove screws that attach plenum to burner to

remove plenum.

5. Remove three screws from deflector shield

on the inside top of firebox. Set shield and

screws aside.