Desa CGCDV42NR Manuale Utente

www.desatech.com

116236-01E

6. Install rear brick panel first. Rest bottom edge

of panel on back edge of burner assembly (see

Figure 43).

7. Install left side brick panel by sliding it be-

tween the burner assembly and the side of the

firebox (see Figure 43).

8. Install the right brick panel using the same

method described in step 6 for left brick

panel.

9. Replace deflector shield using screws removed

in step 4.

10. Using screws removed in step 4, replace

plenum and attach to burner.

11. Using screws removed in step 3, replace

log/grate assembly. Be careful when replac-

ing log/grate assembly not to chip logs on

burner.

12. Install lava rock and glowing embers. See

Installing Lava Rock and Glowing Embers,

page 26.

13. Close glass door and lock latches on top and

bottom of door and replace screen. See Remov-

ing Glass Door, steps 5 and 6 on page 25.

14. Close top and bottom louvers.

FIREPLACE

INSTALLATION

Continued

Figure 43 - Installing Rear Brick Panel

Rear Brick
Panel

Left Side Brick
Panel

OPERATING FIREPLACE

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol-

low these instructions exactly,

a fire or explosion may result

causing property damage, per-

sonal injury or loss of life.

A. This appliance has a pilot which must be

lighted by hand. When lighting the pilot,

follow these instructions exactly.

B. BEFORE LIGHTING smell all around the

appliance area for gas. Be sure to smell next

to the floor because some gas is heavier than

air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electric switch; do not

use any phone in your building.

• Immediately call your gas supplier

from a neighbor's phone. Follow the

gas supplier's instructions.

C. Use only your hand to push in or turn the

gas control knob. Never use tools. If the knob

will not push in or turn by hand, don't try to

repair it, call a qualified service technician.

Force or attempted repair may result in a

fire or explosion.

D. Do not use this appliance if any part has

been under water. Immediately call a

qualified service technician to inspect the

appliance and to replace any part of the

control system and any gas control which

has been under water.

LIGHTING

INSTRUCTIONS

1. STOP! Read the safety information

above.

2. Open lower louver panel.

3. Turn off all electric power to the fireplace.

4. Push in gas control knob slightly and turn

clockwise

to “OFF”.

5. Wait five (5) minutes to clear out any gas.

Then smell for gas, including near the floor.

If you smell gas, STOP! Follow “B” in the

safety information above. If you don't smell

gas, go to the next step.

6. The pilot is located by the main burner and

should not require accessing for lighting.