Roland RD-700GX Guida Utente
144
Installing the Wave Expansion Board
3.
Insert the Wave Expansion Board connector into a
connector for an SRX Series slot (SRX A or SRX B),
while simultaneously inserting the board holders
into the holes in the Wave Expansion Board.
connector for an SRX Series slot (SRX A or SRX B),
while simultaneously inserting the board holders
into the holes in the Wave Expansion Board.
If the same type of Wave Expansion Board is
installed in the SRX A slot and the SRX B slot, it will
only be possible to select data from the Wave
Expansion Board that was installed in the SRX A
slot.
installed in the SRX A slot and the SRX B slot, it will
only be possible to select data from the Wave
Expansion Board that was installed in the SRX A
slot.
fig.00-04e
4.
Use the Installation Tool supplied with the Wave
Expansion Board to turn the holders in the LOCK
direction, so the board will be fastened in place.
Expansion Board to turn the holders in the LOCK
direction, so the board will be fastened in place.
fig.00-05e
5.
Use the screws that you removed in step 2 to fasten
the cover back in place.
the cover back in place.
After installation of the Wave Expansion Boards has been
completed, check to confirm that the installed boards are
being recognized correctly.
completed, check to confirm that the installed boards are
being recognized correctly.
1.
2.
The name of the installed wave expansion board is
displayed for as long as EXPANSION [A] or [B]
button is held down.
displayed for as long as EXPANSION [A] or [B]
button is held down.
The number of tones and Rhythm Sets contained in the
expansion board is displayed.
The example here depicts what you would see if the SRX-
02 “Concert Piano” Wave Expansion Board were
installed in the SRX A slot.
expansion board is displayed.
The example here depicts what you would see if the SRX-
02 “Concert Piano” Wave Expansion Board were
installed in the SRX A slot.
fig.00-07g
By releasing the button, you go back to the previous
screen.
screen.
If “------” appears next to the name of the slot in
which the board was installed, it may be that the
wave expansion board is not being recognized
properly. Use the procedure in “Turning Off the
Power” (p. 26) to turn the power off, then reinstall
the wave expansion board correctly.
which the board was installed, it may be that the
wave expansion board is not being recognized
properly. Use the procedure in “Turning Off the
Power” (p. 26) to turn the power off, then reinstall
the wave expansion board correctly.
NOTE
Wave Expansion Board (SRX series)
Board holder
Position them as shown
before you install the board.
Connector
LOCK
Installation tool
Checking the Installed Wave
Expansion Boards
Expansion Boards
NOTE
RD-700GX_e.book 144 ページ ２００８年２月１３日 水曜日 午後５時４９分