U-Line clrco2175b40 Guida Utente

CLR2160, CLRCO2175

and will correct itself within the first 24 hours of
operation.

3. Re-install the evaporator cover.

Note: On CLRCO2175 model, after the first slab of ice is
produced, ice production will stop until the refrigerator
side reaches the setpoint temperature, then ice
production will begin again.

Allow the unit to run for at least 24 hours to stabilize
before making any temperature or ice adjustments.

IMPORTANT

• U-Line recommends the unit be allowed to run

overnight prior to loading the Model CLRCO2175
refrigerator with product.

IMPORTANT

• On ice maker equipped units, it is possible that

dirt or scale will dislodge in the water line.
Always throw away all ice cubes made during the
first two to three hours of operation.

Turn Unit On/Off

Touch and hold the POWER icon on the display panel for
approximately five seconds until the “F” symbol flashes,
then release.

• A small LED above the icon will illuminate to confirm

the touch of any icon.

• The CLR2160 display will show “ICE” when the unit is

on and will show “OFF” when the unit is off.

The CLRCO2175 display will show the set-point
temperature (38°F) when the unit is on and will show
“OFF” when the unit is off (Figure 15).

• Turning the unit off will override any other control

function.

Temperature Digital Display

The electronic control with digital display is configured to
show a single temperature continuously. The setpoint
temperature is used by the controller to maintain the
temperature zone in the unit. The factory default setpoint
temperature is 38°F.

CHANGING FARHENHEIT/CELSIUS

Units supplied for 110 VAC operation have temperatures
displayed in Fahrenheit (°F). Units supplied for 220 VAC
operation have temperatures displayed in Celsius (°C).

Press and hold the LIGHT icon (Figure 15), then within 5
seconds press the COOLER icon three times to change the
display (°F to °C or °C to °F).

DISPLAYING INTERIOR REFIGERATOR TEMPERATURE
- MODEL CLRCO2175 ONLY

1. Touch and hold the WARMER icon (Figure 16) for

approximately five seconds and release when the °F
symbol in the display begins to flash.

2. The display will show the actual refrigerator

temperature.

ADJUSTING TEMPERATURE SETPOINT
- MODEL CLRCO2175 ONLY

Note: The CLRCO2175 refrigerator section temperature is
adjustable. The storage bin temperature in the
CLRCO2175 and CLR2160 is not adjustable.

IMPORTANT

Adjust the setpoint temperature in single
increments and wait 24 hours for the temperature
to stabilize before rechecking.

Figure 16

1. Press and release either the WARMER or COOLER icon

(Figure 16) to enter the SET TEMPERATURE mode. The
°F symbol will begin to flash.

Note: If no further action is taken, this mode will self-
cancel in five seconds and the original setpoint
temperature will be displayed.

2. While the °F symbol is flashing, press the WARMER or

COOLER icon to adjust the setpoint as desired.

3. After five seconds, the new setpoint temperature will

be displayed.

Interior Lighting
- Model CLRCO2175 Only

The refrigeration section is illuminated whenever the
door is opened.

The light can be set for a Blackout mode which will cause
the display and interior light to go dark.

To access the Blackout mode:

1. Touch and hold the LIGHT icon (Figure 17) for ten

seconds and release (the °F symbol will flash briefly at
the end of the five second period).

2. The interior light and control display will go dark.

Note: Although the display will not be visible, the
temperature controls in the unit remain active and the
interior temperature will be maintained.

3. To exit the Blackout mode, repeat step 1.

OPERATION

Display

Warmer

Cooler