Incra 2000 Guida Utente

2

Place the INCRA Miter Gauge in
the left hand miter slot at your

table saw.  Loosen the (2) 

1

⁄

4

- 20

socket head cap screws that secure
the fence to the fence mounting
bracket and slide the fence to a
position that leaves safe clearance
between the end of the fence and the
blade.  Tighten the (2) 

1

⁄

4

- 20

fasteners.  Fig. 2.

Remove the INCRA Miter Gauge
from the box.  Pivot the miter

head around until the hole in the
black bottom plate aligns with the
threaded hole in the miter bar.  Insert
the large miter push knob with
washer through the hole and thread
into the miter bar.  See Fig. 1. 

NOTE:
Do not insert the handle through
the slotted hole.

If the miter slot in your table saw is a
T-slot, attach the “T” clip to the end of
the miter bar as shown in Fig 1A.

Hole in bottom plate aligned
over threaded hole in miter bar

Miter push knob

Washer

Bottom plate

Miter bar

Insert miter push knob through hole in
bottom plate and thread into miter bar.

First:  Loosen (2) 

1

/

4

-20 socket head cap screws

Clearance between 
fence and blade
(at ALL fence angles)

Position fence

Second:  Slide fence

Third:  Tighten fasteners

Assemble miter
bar clip

#10-24 x 

5

/

16"

flat head screw

T-clip

Miter bar

The method used to join the fence mounting brackets to the miter 

head top plate makes it easy to fine-tune the angle of the fence perfectly

perpendicular to your table top. To adjust, loosen the (3) #10- 24 socket head
cap screws that secure the brackets to the top plate and slide a paper or
plastic shim between the bracket and top plate.  Placing the shim 

behind the

screws will 

decrease the fence to table angle.  Placing the shim in front of

the fasteners will 

increase the fence to table angle.