Incra 2000 Guida Utente

To adjust the Miter Gauge to 

1

⁄

2

° settings, remove the large

miter push knob from the hole in the top plate and thread it

into the slotted hole.  See Fig. 8. Before tightening the knob,
rotate the miter head to move the white “minus” sign engraved
in the black plate toward the knob.  Tighten the knob.  Now at
every tooth setting for the actuator subtract

1

⁄

2

°.  (Example: If

the actuator tooth is locked at 5°, you are at 4

1

⁄

2

°.)  

If you want to add

1

⁄

2

° to every tooth setting, loosen the

miter push knob and rotate the miter head to move the

white minus sign away from the knob.

For continuous angle adjustment the miter push

knob should be installed in the hole, not the slot, on the
black bottom plate.

If you need angle settings finer than 

1

⁄

2

° increments, just

pivot the actuator away from the miter head teeth.  You’ll

notice a white hairline cursor engraved in the black plate.  Use
this hairline as a reference for your adjustments.  For continuous
angle adjustments use only the miter lock thumbscrew to hold
your angle.  

Rotate  miter head top plate to
desired angle, then firmly engage

tooth on actuator with teeth on miter
head.  The actuator tooth should point
directly to the desired angle on the
scale.  Tighten the miter lock
thumbscrew, then tighten the actuator
thumbscrew. Fig. 7.

Loosen the actuator thumbscrew
and pivot the actuator tooth away

from teeth on miter head top plate.
Loosen the miter lock thumbscrew.
See Fig. 6.

First: 
Loosen actuator thumbscrew
and pivot actuator tooth
away from miter head teeth

Unlock miter
head top plate

Second: 
Loosen 
miter lock
thumbscrew

Miter head top plate teeth

Actuator
thumbscrew

Actuator
tooth

First:  Rotate miter head
to desired angle and
firmly engage actuator
tooth with teeth on miter
head top plate.

Rotate and engage
actuator, then relock

Second:
Tighten 
miter lock
thumbscrew

Third: 
Tighten actuator thumbscrew

4

For 

1

⁄

2

° indexing insert miter

push knob through slotted
hole in bottom plate

Miter push knob

Bottom
plate

Slotted hole

After making any adjustments to

the miter angle of your INCRA Miter
Gauge, always verify safe clearance
between the fence and the blade
before turning on the saw.