Cisco Cisco MeetingPlace IP Gateway
6
Release Notes for Cisco MeetingPlace IP Gateway Release 5.2
OL-5698-01
Documentation Updates
Condition: Participants using Cisco IP phones cannot place a call to Cisco MeetingPlace on hold;
otherwise, the call is disconnected.
otherwise, the call is disconnected.
•
CR22580
Symptom: Registry settings are reset after upgrading IP gateway software.
Condition: An upgrade to the MeetingPlace IP Gateway resets the configuration settings to the
default values.
default values.
Documentation Updates
This section contains the latest documentation updates, including any changes or late-breaking
information that occurred after production of the gateway and information that was omitted.
information that occurred after production of the gateway and information that was omitted.
Changes
The changes listed in
have been made in the
Release 5.2
.
Table 2
Changes to Cisco MeetingPlace IP Gateway System Manager’s Guide Release 5.2
Page
Description
3-3
The fifth bulleted paragraph in Network Requirements has been changed to:
The secondary Ethernet connections (those connected to the Multi Access Blade, and not the
second Ethernet port on the CPU card) on MeetingPlace must be connected to the same subnet
as your corporate network where your IP phone is connected. For optimal voice quality, the
ethernet switch port (or any other network devices) that the Multi Access Blade connects to
directly must be set to 100Base-TX Full Duplex.
second Ethernet port on the CPU card) on MeetingPlace must be connected to the same subnet
as your corporate network where your IP phone is connected. For optimal voice quality, the
ethernet switch port (or any other network devices) that the Multi Access Blade connects to
directly must be set to 100Base-TX Full Duplex.
3-4
The following text was added to the Step 4 note on Worksheet 3-1: Installing MeetingPlace IP
Gateway:
Gateway:
The ethernet switch port (or any other network devices) that the Multi Access Blade connects
to directly must be set to fixed 100Base-TX Full Duplex.
to directly must be set to fixed 100Base-TX Full Duplex.
5-7
Step 1 in the “IP Ports Do Not Answer” section now states:
Check that the ethernet switch port (or any other network devices) that the Multi Access Blade
connects to directly is set to fixed 100Base-TX Full Duplex.
connects to directly is set to fixed 100Base-TX Full Duplex.
Subsequent steps have been renumbered.
5-8
Step 1 in the “IP Calls Connect But No Audio Is Heard” section has been changed to:
Verify the subnet mask address is correct using the blade command. If it is not, MeetingPlace
will not be able to send voice packets to the phone. A MeetingPlace audio server restart is
necessary for any changes to take affect.
will not be able to send voice packets to the phone. A MeetingPlace audio server restart is
necessary for any changes to take affect.
Subsequent steps have been renumbered.