Cisco Cisco Unified MeetingPlace Audio Server Manuale Di Manutenzione
4-39
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 4 Configuring the 8112 Server
Configuring the system
Figure 4-44 Modifying the Port Group
Step 3
Type the appropriate port group record number. In this example, it is port group 0, so type
0
and press
Enter. The rest of
appears.
Step 4
Type
y
and press Enter to activate the port group.
Step 5
Type
T1
and press Enter to select the card type. Continue typing and entering the appropriate values for
the system configuration.
Step 6
Type
protocol table
and press Enter to select signaling.
Step 7
Select the appropriate protocol table number. In this example, it is protocol table 2, so type
2
and press
Enter. Refer to
for a list of default protocol tables.
Note
The protocol table contains the configuration information for the type of signaling used. All T1
PRI systems are shipped from the factory with protocol table 2 set to use the default setting of
AT&T PRI protocol, protocol table 3 to use Nortel PRI, and table 4 to use Bell PRI. If this is not
correct for your system, it can be changed via the “protparm” command. Refer to the
PRI systems are shipped from the factory with protocol table 2 set to use the default setting of
AT&T PRI protocol, protocol table 3 to use Nortel PRI, and table 4 to use Bell PRI. If this is not
correct for your system, it can be changed via the “protparm” command. Refer to the
for more information on the “protparm” command.
Note
If this is part of an upgrade from a pre-5.1 release, the default protocol tables 3 and 4 will not
be correct. To resolve this, use the “protparm” command to delete tables 3 and 4. This restores
them to the defaults as listed in
be correct. To resolve this, use the “protparm” command to delete tables 3 and 4. This restores
them to the defaults as listed in
.
Step 8
Repeat this procedure if more than one port group is needed.
Step 9
Type
x
and press Enter to exit the “port” utility.
Enter command: 5
Enter port group record number [0..31] : 0
------------ GROUP 0 --------------
--- To skip over a field, just press <cr> ---
Activate the group? [y] : y
Card type [ T1] : T1
Signaling [ ] : protocol table
Protocol table [ 0] : 2
Number of DID digits [ 0] :
Human assistance? [n] :
Flash transfer? [n] :
Outdial? [y] :
Enter command: x