Cisco Cisco Unified MeetingPlace Audio Server Manuale Di Manutenzione
4-47
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 4 Configuring the 8106 Server
Configuring the system
Note
There are two QSIG variants: QSIG ECMA and QSIG ETSI. You must be sure to use the same variant
that the customer’s PBX is set up to use. QSIG ECMA is the default for protocol table 1. If QSIG ETSI
is needed, the default protocol must be changed.
that the customer’s PBX is set up to use. QSIG ECMA is the default for protocol table 1. If QSIG ETSI
is needed, the default protocol must be changed.
Assigning ports to port groups
You can assign specific ports to port groups so that all ports in that group have the same parameters.
Step 1
At the tech$ prompt, type
port
and press Enter.
appears.
Step 2
Type
2
and press Enter to modify a port record. The first line in
appears.
Figure 4-54 Assigning Port Record
Step 3
Type the port number and press Enter. In this example, it is port 0, so type
0
and press Enter. The rest
of
appears.
Step 4
Enter the number of the port group and press Enter. In this example, it is port group 0, so enter
0
and
press Enter.
Note
If you would like to copy this port record to other ports, refer to the
Step 5
Type
x
and press Enter to exit the “port” utility.
Copying port records
Copying port records provides an easy way to copy the port record for one port to as many ports as
desired. Follow these steps to do this:
desired. Follow these steps to do this:
Table 4-8
Default Protocol Table Settings — E1
Protocol Table Number
Default Protocol
0
Euro ISDN
1
QSIG ECMA
Enter port record number [0..91] : 0
------------- UNIT 0 PORT 0 --------------
--- To skip over a field, just press <cr> ---
Uses port group [ 2] :