Cisco Cisco Unified MeetingPlace Audio Server Manuale Di Manutenzione
4-48
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8106)
78-16411-01
Chapter 4 Configuring the 8106 Server
Configuring the system
Step 1
If you are not already accessing the “port” command, at the tech$ prompt, type
port
and press Enter.
See
.
Figure 4-55 Copying Port Records
Step 2
Type
3
and press Enter to copy port records.
Step 3
Enter the port number you want to copy from and press Enter, as shown in line 14 of
this example, it is port 0, so type
0
and press Enter.
Step 4
Enter the port numbers you want to copy to and press Enter, as shown in line 15 of
. In this
example, all ports are being configured with the same parameters as port 0, so type
1-91
and press Enter.
Step 5
The system tells you which ports were copied to, as shown in line 16 of
.
Step 6
Type
x
and press Enter to exit the “port” utility.
Configuring spans for an E1 system
E1 spans connect to the Multi Access Blade transition modules in the back of the server.
Note
The E1 spans are automatically activated and configured with default settings when the “blade”
command is run.
command is run.
lists the default span configuration.
Check the worksheets in the MeetingPlace Audio Server 5.2 Installation and Planning Guide to see if
your system is configured this way. If these default settings are accurate for this installation, you do not
need to complete this section. If the default settings are not accurate for this installation, complete the
steps that follow.
your system is configured this way. If these default settings are accurate for this installation, you do not
need to complete this section. If the default settings are not accurate for this installation, complete the
steps that follow.
meetingplace:tech$ port
MeetingPlace is up
***** P O R T / G R O U P C O N F I G M E N U *****
1) View port record(s)
2) Modify port record
3) Copy port records
4) View group record(s)
5) Modify group record
x) Exit program
Enter command: 3
Enter port record number to copy from [0..91] : 0
Enter port(s) to copy to [0-91] : 1-91
Copied to port record(s) 1-91.
Enter command: x