Cisco Cisco IPS 4255 Sensor
16
Release Notes for Cisco Intrusion Prevention System 6.1(1)E1
OL-17173-01
After Upgrading to Cisco IPS 6.1(1)E1
Step 5
Enter the password when prompted.
Enter password: ********
Step 6
Enter
yes
to complete the upgrade.
Note
Major updates, minor updates, and service packs may force a restart of the IPS processes or even
force a reboot of the sensor to complete installation.
force a reboot of the sensor to complete installation.
Note
The operating system is reimaged and all files that have been placed on the sensor through the
service account are removed.
service account are removed.
For More Information
•
For more information on obtaining service contracts, see
.
•
For the procedure for locating software on Cisco.com and obtaining an account with cryptographic
privileges, see
privileges, see
After Upgrading to Cisco IPS 6.1(1)E1
This section provides information about what to do after you install Cisco IPS 6.1(1)E1. It contains the
following topics:
following topics:
•
•
•
•
Comparing Configurations
Compare your backed up and saved 6.0 configuration with the output of the show configuration
command after upgrading to 6.1(1)E1 to verify that all the configuration has been properly converted.
command after upgrading to 6.1(1)E1 to verify that all the configuration has been properly converted.
Caution
If the configuration is not properly converted, check the caveats for Cisco IPS 6.1(1)E1 or check
Cisco.com for any upgrade issues that have been found. Contact the TAC if no DDTS refers to your
situation.
Cisco.com for any upgrade issues that have been found. Contact the TAC if no DDTS refers to your
situation.
For More Information
•
For the procedure for showing the output of the show configuration command, refer to
.
•
For a list of IPS 6.1(1)E1 caveats, see
.