Cisco Cisco WAP4410N Wireless-N Access Point - PoE Advanced Security
Release Notes for WAP4410N Access Point Firmware Version 2.0.6.1
3
Release Notes
•
CSCts76476—The access point may periodically experience loss of
connectivity when configured in bridge mode. Workaround: Unplug the
power adaptor or PoE cable, and then plug it back in.
connectivity when configured in bridge mode. Workaround: Unplug the
power adaptor or PoE cable, and then plug it back in.
•
CSCtz05399—The WAP4410N displays only one IPv6 address when set
to IPv6 autoconfiguration. For example, if the router is advertising multiple
prefixes, a local (fec0::) and a global site (2001::), the access point only
acquires one of the two addresses.
to IPv6 autoconfiguration. For example, if the router is advertising multiple
prefixes, a local (fec0::) and a global site (2001::), the access point only
acquires one of the two addresses.
•
CSCtz59478—When enabling or disabling the VLAN or QoS features, your
Internet connection will be lost. Workaround: After configuring the VLAN or
QoS features, unplug the power adaptor or PoE cable, and then plug it back
in.
Internet connection will be lost. Workaround: After configuring the VLAN or
QoS features, unplug the power adaptor or PoE cable, and then plug it back
in.
Changes Since WAP4410N Firmware Version 2.0.4.2
The firmware was updated and the following issues were fixed in firmware version
2.0.5.3.
2.0.5.3.
•
CSCtz79093—Wireless isolation functionality between (and within) SSIDs
is now fixed.
is now fixed.
•
CSCtz79020—Fixed inability to assign static IPv6 address using the web-
based configuration utility.
based configuration utility.
•
CSCtz79064—Added a separate IP-type setting option for IPv6 in the
web-based configuration utility.
web-based configuration utility.
•
CSCty33244—WPS can now be disabled using SSH.
•
CSCty33308—WPS is disabled by default. However, a factory reset must
be performed first — either press the Reset button for approximately 10
seconds, or use the web-based utility. Alternatively, you may choose to
disable WPS using SSH.
be performed first — either press the Reset button for approximately 10
seconds, or use the web-based utility. Alternatively, you may choose to
disable WPS using SSH.
Known Issues
These known issues were identified in firmware version 2.0.5.3.
•
CSCtz79103—When selecting a 128-bit WEP key and providing a
passphrase, one 128-bit key is generated. However, the default transmit
key radio buttons allow you to pick from keys 1 through 4. The radio buttons
for keys 2, 3, and 4 should be disabled.
passphrase, one 128-bit key is generated. However, the default transmit
key radio buttons allow you to pick from keys 1 through 4. The radio buttons
for keys 2, 3, and 4 should be disabled.