Cisco Cisco D9804 Multiple Transport Receiver Guida All'Installazione

 

2 

78-4042990-01 Rev B 

Proceed as follows to connect the D9804 MTR to other equipment. 

 

1  Connect the L-Band signal to one of four RF inputs. 

Note: The LNB power is only available on ports RF1 to RF3.  The factory default 
setting for LNB power is OFF. 

2  If desired, connect the ASI IN port to an asynchronous serial interface device for 

uplink monitoring. 

3  Connect the ASI OUT ports to an asynchronous serial interface device. 

Important: A double-shielded coaxial cable is required to connect to the ASI 
OUT and/or the ASI IN port in order to meet EMC requirements.  

If desired, the appropriate RJ-45 mating connector may be used for remote 
monitoring and control either via SNMP or the built-in Web browser. 

1  Connect the power cord (supplied with the unit) between the rear panel power 

receptacle and a 100V to 240V, 50/60 Hz ac power outlet. 
The power cord (consisting of appliance coupler, flexible cord, and plug) 
supplied with this product meets the requirements for use in the country for 
which this product was purchased. In general, the power cord must be approved 
by an acceptable, accredited agency responsible for evaluation in the country 
where the product will be used. 

2  Connect the Alarm connector on the D9804 MTR to the external alarm 

monitoring equipment. For further information, see Connecting an External 
Alarm System (on page 22). 

3  If required, use the Ethernet port on the D9804 MTR for external control and 

monitoring via web or SNMP. 

4  Connect AC power to both of the rear panel power supplies for proper 

functioning.