Cisco Cisco D9804 Multiple Transport Receiver Guida All'Installazione
Chapter 1 Quick Setup - Read Me First!
4
78-4042990-01 Rev B
Steps using the Front Panel
Locking/Unlocking the Front Panel
The front panel can be locked or unlocked using the front panel keypad.
Proceed as follows to unlock the front panel using the front panel keypad:
1 At the Main Menu, press SELECT and then INFO. This will unlock the front
1 At the Main Menu, press SELECT and then INFO. This will unlock the front
panel keypad and allow you to make changes to all the operating parameters;
however, if the keypad remains untouched for the duration of the set timeout
period (default is 60 seconds), the keypad will change back to the Lock state
unless you change the keypad state on the Admin Menu. Likewise, you can
toggle the keypad lock state back using SELECT and INFO at any time, provided
the KB Lock state on the Admin Menu is Enabled.
however, if the keypad remains untouched for the duration of the set timeout
period (default is 60 seconds), the keypad will change back to the Lock state
unless you change the keypad state on the Admin Menu. Likewise, you can
toggle the keypad lock state back using SELECT and INFO at any time, provided
the KB Lock state on the Admin Menu is Enabled.
2 To disable Lock completely, navigate to Setup, Admin, KB Lock in the LCD
display and press the SELECT key.
3 Change the KB Lock state from Enabled to Disabled.
4 The front panel will now be unlocked, allowing you to change any of the
4 The front panel will now be unlocked, allowing you to change any of the
operating parameters.
To lock the front panel, perform the same procedure, except use the right arrow key
to change the state. In this case, you will not be prompted to confirm the operation.
to change the state. In this case, you will not be prompted to confirm the operation.
Setting Up the IP Parameters of the D9804 MTR
Follow the procedure below when a D9804 MTR is added to or reinserted in the
installation.
installation.
Proceed as follows to set the IP parameters of the Ethernet port of the D9804 MTR:
1 Press the MENU key on the front panel of the D9804 MTR.
1 Press the MENU key on the front panel of the D9804 MTR.
The MENU key toggles between the start up display and the Main Menu.
2 From the Main Menu, press the RIGHT arrow key to navigate to the Ethernet
menu by selecting Setup, then IP. Press the SELECT key. You have now entered
the IP menu.
the IP menu.
3 Go to the required menu item and press SELECT to access the IP Address, Mask,
and Gateway. Use the right and left arrow keys to navigate the IP sub-menu and
if necessary, change any of the values.
Use the right arrow key to navigate to the digits you want to change and press a
numeric key to enter a value. Press the SELECT key to store the entered value(s).
if necessary, change any of the values.
Use the right arrow key to navigate to the digits you want to change and press a
numeric key to enter a value. Press the SELECT key to store the entered value(s).
4 If necessary, change the other IP parameters as described in steps 2 and 3 above.
5 Press the MENU key to exit the IP menu. You are prompted with the following
5 Press the MENU key to exit the IP menu. You are prompted with the following
menu options: