Cisco Cisco D9804 Multiple Transport Receiver Guida All'Installazione
Steps using the Front Panel
78-4042990-01 Rev B
5
Menu Prompts
Description
Save
Saves the changes and returns to the IP menu.
SaveExit
Saves the changes and exits to the main menu.
Exit
Discards the changes and exits to the main menu.
Cancel
Cancels the changes and returns to the IP menu.
Note: When you exit the IP menu, if a problem is detected with the submitted
values, parameter errors are displayed. For example, enter 0 for the Mask
parameter and the “Netmask is out of range” error message appears when you
attempt to exit the menu. In this instance, you need to return to the menu item
and enter a valid parameter.
values, parameter errors are displayed. For example, enter 0 for the Mask
parameter and the “Netmask is out of range” error message appears when you
attempt to exit the menu. In this instance, you need to return to the menu item
and enter a valid parameter.
Configuring the Operational Mode
The D9804 MTR can be configured to be in Base mode (version 1.00) or Deterministic
Multiplexing (DM) mode (version 2.00). For more information, see Operational
Modes: Base or Deterministic Multiplexing (DM) (on page 13).
Multiplexing (DM) mode (version 2.00). For more information, see Operational
Modes: Base or Deterministic Multiplexing (DM) (on page 13).
Setting up RF Tuning Parameters
1 Move to the Tuning menu and use the up and down arrow keys to navigate to
and set the following parameters.
Entry/Selection
Options
Enabled
Set to Yes to enable the input.
Inband Data
Set to Ignore to use local data.
Input
4 RF ports to select.
Modulation
DVB-S or DVB-S2. If set to DVB-S2, set FEC to Auto.
Downlink Frequency Type in frequency (GHz).
Set FEC
If the FEC is unknown, leave it at "auto". It must be set to Auto if
DVB-S2 modulation is used.
DVB-S2 modulation is used.
Set LNB Voltage
RF1, RF2, and RF3
Note: Only RF1 to R3 have DC power.
LNB Voltage options - 13, 18, and OFF.
Set LO frequency
LO (Local Oscillator) frequency in GHz.
Rolloff
Only required for DVB-S2.
IQ
Normal, Inverted, or Auto.
2 Press MENU to exit and save the changes.