Cisco Cisco TelePresence MX700 Nota Di Rilascio
Known limitations
Cisco TelePresence System C-Series Software Release Notes
Page 77 of 133
the default call protocol to SIP.
66993
Ver. TC3.x and above
The C-series codecs will reduce the
presentation resolution if you are unable to
sustain a minimum of 1 frame per second.
sustain a minimum of 1 frame per second.
Any
1920*1200p60 output resolution will run in DVI
compatibility mode and hence audio cannot be
transmitted over HDMI when using this
resolution.
75341
Ver. TC3.x and above
If you dial a TANDBERG 150 with SW version
L5.1.1 or older with encryption setting set to
‘on’, you may not get audio in any direction.
‘on’, you may not get audio in any direction.
75382
TC3.0.0 and above
The call tab on the web interface doesn’t work
properly with Opera. You can dial, but you will
not get the call status.
82627
TC3.0.0 and above
The call status on the web interface will not be
displayed if you access the codec using
HTTPS.
HTTPS.
75045
TC2.x.x and above
When setting the H.323 id to
"number.something@domain", the endpoint
becomes unreachable. The workaround is to
not let H.323 ID start with a number.
TC3.0.0 and above
The Cisco TelePresence System codec
C40/C60 (rev. 1), will not provide proper
analogue VGA output for any resolution of 1080
analogue VGA output for any resolution of 1080
lines or more.
Any
The Cisco TelePresence System codec C40
will reduce its capability set when using internal
MultiSite. When this is done, the main stream
will maximum be able to transmit w576p until all
calls are disconnected.
calls are disconnected.
Any
The Cisco TelePresence System codec C60
will reduce its capability set when using internal
MultiSite. When this is done, the dual stream
will maximum be able to transmit WXGA until all
calls are disconnected.
Any
The Cisco TelePresence System EX60/90 does
not support usage of the remote control. The
Cisco TelePresence Touch Screen must be
used to control these devices.
78636
TC4
A search in the local phonebook will list all
contacts including those in the subfolders.
83992
TC4
To use SIP verified, a CA list must be uploaded
to the /user folder using SCP (root user must be
to the /user folder using SCP (root user must be
enabled). The CA list must be named
‘sipcalist.pem’ and be in DER format.
Polycom
Reference ID
Equipment
Summary
Polycom MGC
9.0.3.1
60 frames per second was disabled during the
testing (Advanced
Configuration/Video/Input/Source/Optimal
Definition/Threshold60fps = Never).