Cisco Cisco TelePresence MX700 Nota Di Rilascio
Open caveats
Cisco TelePresence System C-Series Software Release Notes
Page 79 of 133
Open caveats
Reference ID
Summary
88976
ClearPath: H.323 down speeding of the presentation channel (H.239) is not
disabled when using ClearParh.
89291
The IP address is not changed upon reboot when a different configuration profile is
selected.
87563
TC4.x.x software do not handle the H.263+ from the TANDBERG MPS GateWay,
the image will never clear up. This problem can be seen when dialing from a
TANDBERG MXP through ISDN into the MPS GateWay, which again connects to
a C-series system with TC4.x software. The problem is not seen with TC3.x
software.
87376
Microsoft OCS registration is broken in TC4.x.x
81993
The Cisco TelePresence System codec C40 is unable to automatically detect a
Digital Natural Audio Module (DNAM) in software versions previous to TC4. This
will cause the codec to output analog audio instead of SPDIF (digital). If connected
to a DNAM for software versions previous to TC4 it is recommended to set the
audio output to SPDIF manually.
83374
The C-series codecs and units with such a codec inside it do not meet the Cisco
password policy. It is highly recommended to set a password on the unit during
install using the API command: ‘systemtools passwd’
84314
A C20 participating in a MultiSite will not be able to send the following video
formats in its main video channel: 1280*768, 1280*800 and 1440*900.
84157
Rebooting the unit will always reset ScaleToFrameThreshold to default value.
84032
Web snapshot is available in the web interface of the EX90 and EX60 even though
these units do not support this functionality.
83933
If any of the Corporate Directories contains any sub directories, the first 15 entries
will be listed twice.
82631
Missing upgrade status when upgrading through web. You will not be able to see if
the upgrade was successful or not when upgrading through the web interface.
82535
API command ‘systemtools rootsettings get’ return ‘off’ even if root is set to ‘on’
81740
When in a MultiSite call, the encryption status symbol will only reflect the status of
the last call.
If the ‘admin’ user is deleted, then TMS will not be able to manage the system. At
the same time the ‘admin’ user will be recreated with blank password during next
reboot.
reboot.
xFeedback register Event/KeyDown will now mask the keys pressed on the
remote control with a ‘*’. This is a security measurement to prevent key logging
from the remote control. The ‘*’ can be used to detect that someone has pressed a
button on the remote control.
84734
When upgrading from TC3.x.x it has been seen that the SIP registration becomes
inactive. To resolve this issue toggle the ‘SIP mode’ to ‘Off’ and back to ‘On’ again.
inactive. To resolve this issue toggle the ‘SIP mode’ to ‘Off’ and back to ‘On’ again.