Cisco Cisco TelePresence MX700 Nota Di Rilascio
Known limitations
Cisco TelePresence System C-Series Software Release Notes
Page 78 of 133
MGC conference is set to continuous presence,
AES and H.239:
Far End Camera Control is not working.
Far End Camera Control is not working.
Call rates down to 256kbps works fine. 256kbps
and lower will experience loss of video.
MGC conference set to voice switched, AES
MGC conference set to voice switched, AES
and H.239:
Following conference rates does not work:
Following conference rates does not work:
1.1Mbps
MGC conference is set to continuous presence,
MGC conference is set to continuous presence,
no AES and H.239:
H.239 does not work very well with the MGC. A
H.239 does not work very well with the MGC. A
lot of issues was seen when testing H.239.
64418
C Series
Ver. TC2.1.0
(No Video
Polycom VSX Ver. 9.0.5)
Currently if the video source 1 (PrecisionHD
1080p camera) is set to sharpness then the
Polycom VSX will not display video as the
TANDBERG codec will transmit w448p, which
is not supported by the VSX. Workaround: Set
is not supported by the VSX. Workaround: Set
PrecisionHD 1080p camera to motion.
N/A
C Series
Ver. TC2.1.0
(No Video
Polycom VSX Ver. 8.0 & 8.5)
The Polycom VSX may display distorted video
from the TANDBERG codec. Workaround:
Upgrade the Polycom VSX to software version
8.7 or higher.
RadVision
Reference ID
Equipment
Summary
RadVision
Scoopia 400
MCU
Scoopia 400
MCU
5.7.1.0.13
If a Cisco TelePresence System C20 is
connected to a 1080p conference and starts
presentation, the C20 will not display incoming
video.