Cisco Cisco TelePresence MX700 Guida All'Installazione

1.

Configuring H.323 and SIP

(when not set by a provisioning system)

to get online and ready to place and receive calls, your system

must be set up properly. Your system uses either the H.323

protocol or the SiP protocol for video calls.

NoTe:

Contact your system administrator, or service provider,

for information about the network settings.

for networks administered through Cisco tMS (Cisco

telePresence Management Suite) your Cisco tMS adminis-

trator will help you to get online.

You can find information about admininistering through Cisco

uCM in the

guide.

H.323

if in doubt about any of the parameters below, contact your

system administrator or your service provider.

1. tap

2. enter the

and

in their respective

input fields.

3. if you want to enter the address of the H.323 gatekeeper

manually, tap

in the

section,

and enter the

in the input field.

otherwise tap

.

4. if the H.323 gatekeeper requires authentication and you

want your system to authenticate itself to the gatekeeper,

tap

in the

section and enter the

and

in their respective input fields.

otherwise, tap

.

5. tap

to save the changes, or

to leave without

saving.

6. tap

twice to review the System information page and

verify the H323 settings.
if you successfully registered to the Gatekeeper the

is shown as

in the H323 section.

7. tap

to return to the home menu.

SIP

if in doubt about any of the parameters below, contact your

system administrator or your service provider.

1. tap

2. enter the SiP uri in the

input field.

3. tap the preferred transport protocol in the

section. if you select

, the system first tries to connect

using tlS, then tCP, and finally udP.

4. Select a

. Step through the list of available

proxy types by tapping the - or + signs. the default type

is

.

5. if you want to enter the SiP proxy address manually, tap

in the

section and enter the

in the input field. if you want the system to obtain

the SiP proxy address automatically (dHCP), tap

.

6. if the SiP proxy server requires authentication you must

enter the

and

in their respective

input fields to authenticate your system.

7. tap

to save the changes, or

to leave without

saving.

8. tap

twice to review the System information page and

verify the SiP settings.
if you successfully registered to a SiP server the

is

shown as

in the SiP section.

9. tap

to return to the home menu.

Back to task overview

Cisco telePresence Video Systems

d14639.08 Video Systems Getting Started Guide tC6.0, february 2013.

Copyright © 2010–2013 Cisco Systems, inc. All rights reserved.

15

Getting Started Guide

Contents

Introduction

User interfaces

Configuration

Appendices

Contacts

Configuration