HP designjet l65500 Manuale

●

A substrate cannot be loaded unless all printer subsystems (e.g. the ink system) are ready.

●

If the printer is unaware of the carriage beam position (after a printer recovery or shutdown), go to
the front panel and select the Substrate Management icon 

, then Carriage beam position

> Carriage system recovery.

●

Check that the spindle is correctly inflated.

●

Try using the front panel to advance the substrate at least 10 ft (3 m), then move it back and try to
load it again. If it will not load, perhaps the substrate is not attached to the input core: try a different
roll.

If the printer reports a substrate jam, follow these steps.

If the carriage is still moving or trying to move, press an emergency stop button as quickly as
possible to minimize damage to the printheads.

If the printer shuts itself down automatically before you reach an emergency stop button, turn off
circuit breaker ACB-1.

Wait about ten minutes for the printer to cool down.

ENWW

The substrate cannot be loaded successfully

31