HP digital sender 9200c Manuale Di Servizio
Understanding digital-sender LEDs
Three LEDs on the formatter indicate that the digital sender is functioning correctly.
Figure 7-1
Digital-sender LEDs
1
HP Jetdirect LEDs (“link” LEDs)
2
Formatter “heartbeat” LED
HP Jetdirect LEDs
The embedded HP Jetdirect server has two LEDs, one for each possible link speed. When an LED is
lit, the server is functioning correctly. A link failure is indicated when both LEDs are off.
lit, the server is functioning correctly. A link failure is indicated when both LEDs are off.
For link failures, check all of the network cable connections. In addition, you can try to manually
configure the link settings on the embedded server by using the digital sender control-panel menus.
configure the link settings on the embedded server by using the digital sender control-panel menus.
1
Touch Menu.
2
Touch CONFIGURE DEVICE.
3
Touch I/O.
4
Touch EMBEDDED JETDIRECT MENU
5
Touch LINK SPEED. Select the appropriate link speed.
NOTE
for more information about
troubleshooting HP Jetdirect and other network issues.
Formatter LED
The formatter LED indicates that the formatter is functioning correctly. While the digital sender is
initializing after you turn it on, the LED blinks rapidly, and then turns off. When the digital sender has
finished the initialization sequence, the heartbeat LED pulses on and off.
initializing after you turn it on, the LED blinks rapidly, and then turns off. When the digital sender has
finished the initialization sequence, the heartbeat LED pulses on and off.
If the formatter LED is off, the formatter might have a problem. Remove the formatter cage and re-
seat the memory DIMMs and the flash memory card. Then make sure that the formatter cage is
seated correctly. If the problem persists, replace the formatter. See
seat the memory DIMMs and the flash memory card. Then make sure that the formatter cage is
seated correctly. If the problem persists, replace the formatter. See
Understanding digital-sender LEDs
165