HP pavilion dv6500 6600 6700 Manuale Di Servizio
3
.
Use the optical drive connector (1) to lift the right side of the system board (2) until it rests at an
angle.
4
.
Disconnect the audio board cable (3) from the system board.
5
.
Release the system board (4) by sliding it to the right until the connectors on the left side of the system
board disengage from the base enclosure.
6
.
Remove the system board.
7
.
If it is necessary to replace the USB/power connector board cable, turn the system board upside
down with the expansion port 3 toward you.
8
.
Disconnect the power connector cable (1) and the USB board cable (2) from the system board. The
USB/power connector board cable is included in the Cable Kit, spare part number 446519-001.
Reverse the above procedure to install the system board and USB/power connector board cable.
84 Chapter 4 Removal and replacement procedures