Emerson NGA2000 Manuale Utente

90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98

NGA 2000

If you press the ENTER key or the 

→

→

 -key in the line "Expert controls and set up..." of the

"Main Menu" you will change to the following display:

From the menu "Expert controls and set up" you can change to several submenus to set
up parameters for the measurement and calibration of your analyzer and analyzer module.
Besides you can set up the configuration for auxiliary modules. Which part of these menus
are important for you depends on the configuration of your NGA 2000 system.
In the following table you will find a short overview about the contents of the menus and
where you will find the description in this manual:

⇒ 

Configuration of the SIO and of
the DIO's installed in a platform
or in an MLT analyzer

⇒ 

Set up of the
single component display

⇒ 

Measurement/Calibration
parameters set up

⇒ 

Linearizer parameters set up

⇒ 

Sensor/Converter/Block
parameters set up and
optimization

⇒ 

Set up for micro processor
controlled auxiliary I/O modules

⇒ 

Zero gas and span gas
calibration of all channel
automatically

MAIN

NEXT

INFO

CLD

95.0 ppm

Expert controls and set up

Expert analyzer controls...

Auxiliary module controls...

System set up...
Analyzer module set up...

System calibration...

Auxiliary module set up...