Emerson NGA2000 Manuale Utente

90003749(1) [NGA-e (Software CLD 2.3/MLT 3.1.X)] 04/98

NGA 2000

↓↓

Analyzer module set up

↓↓

From the menu "Analyzer module set up" you can change to several submenus, where
you can set up the measurement and calibration parameters of the CLD analyzer module.
Besides, you can go to those submenus where you can set up the parameters of the
single component display.
Caution:
Normally, you will find "CLD" as analyzer module tag in the line "analyzer tag".
If the CLD module is part of an analyzer network: You have to change the configu-
ration of the programmable digital inputs and analog outputs, if you change the
identification tag ! Because, the parameters of the module source will change ! So,
the relations will disappear !

Set up parameters:

♦ 

Select the menu line you want or the line of variables "Analyzer tag" with
the 

↓↓

 -key or the 

↑↑

 -key.

♦ 

Select the variable or change to the submenu with the ENTER key or the 

→

→

 -key.

♦ 

Select any digit with the 

←

←

 -key or the 

→

→

 -key and adjust a new value with

the 

↑↑

 -key or the 

↓↓

 -key;

Maximum of digits: 30
Options: alphabet (capital and small letters), umlauts, letters from different languages,
0, 1, 2, ..., 9, +, -, *, /, =, ?, !, %, $ and many others.

♦ 

Confirm the new value with the ENTER key or cancel and go back to the last value with
the F2 key.

HOME

ESCAPE

INFO

CLD

95.0 ppm

Analyzer module set up

Calibration gas list...

Gas measurement parameters...

Analyzer parameter list...

Displayed parameters...
Analyzer tag:

CLD

Calibration parameters...

Physical measurement parameters...