Patton electronic industrial ethernet extender with lcd interface 3231 Manuale Utente

Using the CLI

Model 3231 User Manual 

Table 9. G.SHDSL - CLI Commands

Set the number of timeslots that each DSL frame will 
carry. The DSL data rate will be (64 kbps x 
#timeslots) + #ibits.

Set the number of i-bits that each DSL frame will 
carry. The DSL data rate will be (64 kbps x 
#timeslots) + #ibits.

Force the DSL link to retrain. The data rate settings 
will not take effect until this command is issued.

Table 10. CPE Config - CLI Commands

Show the CPE’s configuration

Set the CPE’s line rate. This will not be sent to the CPE 
until the cpeconfig action set command is run. 

Set the CPE’s IP address. This will not be sent to the 
CPE until the cpeconfig action set command is 
run. 

Set the CPE’s netmask. This will not be sent to the CPE 
until the cpeconfig action set command is run.

Set the CPE’s default gateway. This will not be sent to 
the CPE until the cpeconfig action set command is 
run.

Get the CPE’s configuration. This will automatically 
happen each time the DSL link comes up.

Command the CPE to configure itself with the desired 
line rate, IP address, netmask, and default gateway.

Table 11. STP - CLI Commands

Show STP configuration.

Enable/Disable STP.

Set STP forward delay time in seconds.

Set STP hello time in seconds.

Set STP max age in seconds.