Philips hr2027 Manuale Utente

  

 Place the rubber sealing ring on the mill blade unit.  (Fig. 10)

Make sure that the sealing ring is placed correctly.

  

 Put the mill blade unit on the mill beaker (1) and screw the blade unit anticlockwise () until 

it is fixed properly (Fig. 11).

  

 Turn the assembled mill upside down and screw it clockwise onto the motor unit (‘click’)  

(Fig. 1).

 5 

 Put the mains plug in the wall socket.

 6 

 Switch on the appliance and let it run until the ingredients are fine enough.

This takes approx. 10-30 seconds. 

 1 

 Unplug the appliance.

  

 Screw the mill anticlockwise off the motor unit.

  

 Turn the mill upside down and screw the blade unit clockwise off the mill beaker.

  

 Clean all removable parts immediately after use (see chapter ‘Cleaning’).

Always unplug the appliance before you clean it.
Never immerse the motor unit in water, nor rinse it under the tap. Do not clean the motor unit 

in the dishwasher.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone 

to clean the appliance. 
Tip: Cleaning the appliance and its parts is easiest immediately after use.

 1 

 Make sure the appliance is unplugged.

  

 Disassemble all removable parts.

Do not forget to remove the blender sealing ring and the mill sealing ring (HR07/HR01 

only).
Do not touch the blades. The blades are very sharp.

  

 Clean the motor unit with a moist cloth. 

  

 Clean the removable parts in hot water with some washing-up liquid.

 1 

 To store the mains cord, wind it round the reel in the base of the motor unit (Fig. 1).

  

 Screw the blade unit anticlockwise onto the bottom of the blender jar.

  

 Turn the blender jar upside down. 

  

 Put the blender jar on the motor unit. 

 5 

 Place the lid on top of the blender jar (Fig. 14).

10