Hitachi 50GX49B Manuale Utente

EXTERNAL CONNECTIONS 

- 15 - 

Your component outputs may be labeled Y, B-Y, and R-Y. In this case connect the components B-Y output to the TV's CB 
input and the components R-Y output to the TV's CR input. 

It may be necessary to adjust TINT or turn AUTO COLOR-ON to obtrain optimum picture quality when using the Y-CB-
CR inputs. (See pages 47 and 48.) 

To ensure no copyright infringement, the MONITOR OUT output will be abnormal, when using Y-CB-CR jacks. 

When using the Y-CB-CR jacks, Input 2 will be viewed as a blank PIP sub-picture. (See page 22) 

To control the audio level of an external audio amplifier with the remote control, connect the system as shown below. 

 

NOTE: To prevent damage to the speaker and distorted sound, set the volume control of the audio amplifier lower and 
adjust the sound using the remote control of the TV set. 

The exact arrangement you use to connect the VCR, camcorder, laserdisc player  to your TV set is dependent on the model 
and features of each component. Check the owner's manual of each component for the location of video and audio inputs 
and outputs. 

The following connection diagrams are offered as suggestions. However, you may need to modify them to accommodate 
your particular assortment of components and features. For best performance, video and audio cables should be made from 
coaxial shielded wire. 

Before Operating External Video Source 
The input mode is changed every time the INPUT button is pressed as shown below. Connect an external source to the 
INPUT terminal, then press the INPUT button as necessary to view the input source.  (See page 21.) 

 

INPUT MODE SELECTION ORDER