TP-Link Technologies Co. Ltd. TDW8151NV4 Manuale Utente

 

 

7

Before installing the device, please make sure your broadband service provided by your ISP is 
available. If there is any problem, please contact your ISP. Before cable connection, cut off the 
power supply and keep your hands dry. You can follow the steps below to install it. 

Step 1:  Connect the ADSL Line. 

Method one: Plug one end of the twisted-pair ADSL cable into the ADSL port on the rear 
panel of TD-W8151N, and insert the other end into the wall socket. 

Method two：You can use a separate splitter. External splitter can divide the data and 
voice, and then you can access the Internet and make calls at the same time. The 
external splitter has three ports: 

•

  LINE: Connect to the wall jack 

•

  PHONE: Connect to the phone sets 

•

  MODEM: Connect to the ADSL LINE port of TD-W8151N 

Plug one end of the twisted-pair ADSL cable into the ADSL port on the rear panel of 
TD-W8151N. Connect the other end to the MODEM port of the external splitter. 

Step 2:  Connect the Ethernet cable. Attach one end of a network cable to your computer’s 

Ethernet port or a regular hub/switch port, and the other end to the LAN port on the 
TD-W8151N. 

Step 3:  Power on the computers and LAN devices. 

Step 4:  Attach the power adapter. Connect the power adapter to the power connector on the rear 

of the device and plug in the adapter to an electrical outlet or power extension. The 
electrical outlet shall be installed near the device and shall be easily accessible. 

 

Figure 2-4