TP-Link Technologies Co. Ltd. TDW8950ND Manuale Utente
TD-W8950ND
150Mbps Wireless Lite N ADSL2+ Modem Router User Guide
4.5.6.1 Queue Config
Choose “Advanced Setup→Quality of Service→Queue Config”, you can set configure QoS
queues on the screen below.
queues on the screen below.
Figure 4-54
Click the Add button in Figure 4-54, and you can configure the QoS queue entry on the next
screen as shown in Figure 4-55.
screen as shown in Figure 4-55.
Figure 4-55
¾
Queue Configuration Status: Enable or disable the queue configuration.
¾
Queue: Select a QoS queue entry from the drop-down list.
¾
Queue Precedence: Specify precedence for this QoS queue entry.
After you specify the condition, click Save/Apply to save the entry and then you will see you
settings as shown in Figure 4-54.
settings as shown in Figure 4-54.
)
Note:
1) Lower integer values for precedence imply higher priority for this queue relative to others.
2) The queue entry configured here will be used by the classifier to place ingress packets
2) The queue entry configured here will be used by the classifier to place ingress packets
appropriately.
4.5.6.2 QoS Classification
This section will guide you to create a traffic class rule to classify the upstream traffic, assign
queue which defines the precedence and the interface and optionally overwrite the IP header
DSCP byte.
queue which defines the precedence and the interface and optionally overwrite the IP header
DSCP byte.
A rule consists of a class name and at least one condition below. All of the specified conditions in
this classification rule must be satisfied for the rule to take effect.
this classification rule must be satisfied for the rule to take effect.
48