TP-Link Technologies Co. Ltd. TDW8950ND Manuale Utente

Choose “Routing→Default Gateway” menu, you can configure the Default Gateway routing in the 
next screen as shown in Figure 4-59.  

 

Figure 4-59 

¾

 

Enable Automatic Assigned Default Gateway - Select this checkbox, and then the Router will 
accept the first received default gateway assignment from one of the PPPoA, PPPoE or 
MER/DHCP enabled PVC(s). If this checkbox is not selected, you have to enter the static 
default gateway and/or an interface. Click Save/Apply to save your configurations. 

)

If changing the Enable Automatic Assigned Default Gateway from unselected to selected, you 
must reboot the Router to get the automatic assigned default gateway. 

4.5.7.2  Static Route 

Choose “Routing→Static Route” menu, you can view and add the Static Route entry in the next 
screen as shown in Figure 4-60. A static route is a pre-determined path that network information 
must travel to reach a specific host or network. 

 

Figure 4-60 

To add a new entry, follow the steps below. 

1.  Click the Add button in Figure 4-60 to go to the Static Route Add page as shown in Figure 

2.  Enter the IP address of the destination network. This parameter specifies the IP network 

address of the final destination. 

3.  Enter the Subnet Mask for the destination. 

4.  Select the Use Gateway IP Address checkbox and enter the IP address of the gateway. The 

gateway is an immediate neighbor of your ADSL Router that will forward the packet to the 
destination. On the LAN, the gateway must be a router on the same segment as your Router; 
over Internet (WAN), the gateway must be the IP address of one of the remote nodes. 

50