TP-Link Technologies Co. Ltd. TDW8980V1 Manuale Utente

 

32 

Click Save to make the entry effective immediately 

Choose “Network”Æ“LAN Settings” menu, and you will see the LAN screen (shown in Figure 
4-13). Please configure the parameters for LAN ports according to the descriptions below. 

 

Figure 4-13 

¾

  IP Address: You can configure the modem router’s IP Address and Subnet Mask for LAN 

Interface. 

•  IP Address: Enter the modem router’s local IP Address, then you can access to the 

Web-based Utility via the IP Address, the default value is 192.168.1.1. 

•  Subnet Mask: Enter the modem router’s Subnet Mask, the default value is 255.255.255.0. 

¾

  Enable IGMP Snooping: If you select the option, please choose the IGMP Mode: Standard 

Mode or Blocking Mode. 

¾

  Enable Second IP: You can configure the modem router’s second IP Address and Subnet 

Mask for LAN Interface through which you can also access to the Web-based Utility as the 
default IP Address and Subnet Mask. 

¾

  DHCP Server: These settings allow you to configure the modem router‘s Dynamic Host 

Configuration Protocol (DHCP) server function. The DHCP server is enabled by default for the 
modem router’s Ethernet LAN interface. DHCP service will supply IP settings to computers 
which are configured to automatically obtain IP settings that are connected to the modem 
router though the Ethernet port. When the modem router is set for DHCP, it becomes the 
default gateway for DHCP client connected to it. Keep in mind that if you change the IP 
address of the modem router, you must change the range of IP addresses in the pool used for 
DHCP on the LAN. 

•  Start IP Address: Enter a value for the DHCP server to start with when issuing IP 

addresses. Because the default IP address for the modem router is 192.168.1.1, the 
default Start IP Address is 192.168.1.100, and the Start IP Address must be 192.168.1.100 
or greater, but smaller than 192.168.1.254.