AIR802 LLC AP25N01 Manuale Utente
AP25N01 User Manual
13
Basic Wireless
All of the basic wireless settings can be configured in this page. Operators can change
the ESSID, regulatory country code, wireless profile, channel spectrum width, frequency
of interest, data rates, transmit power and rate aggressiveness.
the ESSID, regulatory country code, wireless profile, channel spectrum width, frequency
of interest, data rates, transmit power and rate aggressiveness.
NOTE: When you click the Basic Wireless tab, the Radio Selection box opens. Currently
the device supports only one 802.11n radio card. Click Radio 1 to configure.
the device supports only one 802.11n radio card. Click Radio 1 to configure.
Enable the radio
To enable the radio, click the Enable Radio 1 selection box to place a checkmark in the
box. To disable the radio, click the Enable Radio 1 selection box to remove the
checkmark in the box.
box. To disable the radio, click the Enable Radio 1 selection box to remove the
checkmark in the box.
Wireless Mode
There are five modes available. Click a mode in the Wireless Mode drop-down list.
Station
This is a client mode that can be connected to the Access Point mode. It is used to
bridge the wireless connection to an Access Point. It forwards all the traffic to and from
network devices to the Ethernet interface. This mode translates all the packets that pass
through the device to its own MAC address, resulting in a lack of transparency.
bridge the wireless connection to an Access Point. It forwards all the traffic to and from
network devices to the Ethernet interface. This mode translates all the packets that pass
through the device to its own MAC address, resulting in a lack of transparency.