Honeywell International Inc. WFSLCDUI Manuale Utente
PRELIMINARY: Firelite Wireless Sensor Network P/N LS10036-000FL-E:N0 10/10/2013
27
Operations
W-GATE
Mesh Optimization
In addition to the initial mesh optimization, the routine executes after any restoration of communi-
cation to a device or to recover from a link failure (class A fault). Mesh optimization that occurs
during the normal mode does not generate a trouble and provides fire protection from all devices
that are participating in the mesh communication. The W-GATE reports “Optimization” to the com-
municator display of the PC Tools application.
cation to a device or to recover from a link failure (class A fault). Mesh optimization that occurs
during the normal mode does not generate a trouble and provides fire protection from all devices
that are participating in the mesh communication. The W-GATE reports “Optimization” to the com-
municator display of the PC Tools application.
Bootloader
The W-GATE enters the bootloader mode when it is being updated using the PC Tools application.
The W-GATE does not communicate with the FACP during bootloader mode. The W-GATE
reports “Bootloader” to the communicator display of the PC Tools application.
The W-GATE does not communicate with the FACP during bootloader mode. The W-GATE
reports “Bootloader” to the communicator display of the PC Tools application.
2.7.2 Magnet Sensor Activations
Profile Magnetic Sensor
The profile magnetic sensor (Figure 2.9, "Profile Magnetic Sensor on a W-GATE") is used to create
a unique profile on startup. It can also be used to start profile distribution for a W-GATE that con-
tains a profile. The LED next to the profile magnet sensor emits solid red light for ½ a second
when the sensor is activated.
a unique profile on startup. It can also be used to start profile distribution for a W-GATE that con-
tains a profile. The LED next to the profile magnet sensor emits solid red light for ½ a second
when the sensor is activated.
Mesh Formation Magnetic Sensor
The mesh formation magnetic sensor (Figure 2.8, "Mesh Formation Magnetic Sensor on a W-
GATE") toggles the W-GATE, in and out of mesh formation mode. The initial activation of the sen-
sor puts the W-GATE in mesh formation mode (as long as it contains a profile). A subsequent acti-
vation of the magnetic sensor toggles the W-GATE out of mesh formation and into the initial mesh
optimization and normal mode. The W-GATE can be placed back into mesh formation by activat-
ing the magnet sensor once again. The Mesh formation magnetic sensor can also be used to create
a profile on startup for a W-GATE that does not already contain a profile.
GATE") toggles the W-GATE, in and out of mesh formation mode. The initial activation of the sen-
sor puts the W-GATE in mesh formation mode (as long as it contains a profile). A subsequent acti-
vation of the magnetic sensor toggles the W-GATE out of mesh formation and into the initial mesh
optimization and normal mode. The W-GATE can be placed back into mesh formation by activat-
ing the magnet sensor once again. The Mesh formation magnetic sensor can also be used to create
a profile on startup for a W-GATE that does not already contain a profile.
The LED next to the mesh formation magnetic sensor emits solid red light for ½ a second when the
sensor is activated.
sensor is activated.
2.7.3 LED Indications
The two LEDs on the W-GATE blink in the same pattern to allow the LED to be viewed from any
angle. The LED indications are provided in the table below.
angle. The LED indications are provided in the table below.