C. D. V. I. F0101000019 Manuale Utente
Edition 09/2000
3
Programming mode --- Main menu
Present a proximity badge in front of the control unit proximity reader.
----- If the master badge is not programmed in the control unit, present any proximity badge wait for the
display to switch off and then press on the PROG button to enter in the programming mode.
display to switch off and then press on the PROG button to enter in the programming mode.
----- If the master badge is programmed
Main menu
Present the master badge in front of the control unit reader, wait for the display to switch off and press on the
PROG button (red button). The master badge activates relay 1
PROG button (red button). The master badge activates relay 1
The display indicates the relay is activated. Wait for the display to switch off. press on
the PROG button to enter in the programming mode.
The first LED starts flashing.
MENU 1
Add badges/select door – badge deletion.
MENU 2
Set Door Release Time
MENU 3
Data transferring.
MENU 4
Set Master badge.
MENU 5
Badge Identification.
Press on Nxt or Prv buttons to select a menu. One LED flashes at a time.
Note: If LED 5 flashes (last LED), the user has selected Menu 5. Press on the Ent button to Enter in the Menu.
The LED stops flashing.
The LED stops flashing.
Deleting the master badge and reset to default values
1. Put the jumper on ST1.
The display shows
d during 5 seconds. Then the display switches off during 5 seconds.
The master badge is deleted.
2.
Remove the jumper from ST1.
OR