Tagsys S.A. LIBSECPEDEST2 Manuale Utente
LIBRARY SECURITY PEDESTAL 2
7. Insert the power supply cable into the Electronics Unit through the cable access hole as shown
above. Check that the cable is correctly positioned and that there are no friction points.
8. Insert and fasten the screws in the mounting holes according to the type of ground surface:
a. Wood floor: Insert the screws directly into the mounting holes and tighten the screws in
place.
b. Concrete floor: Insert the screws into the concrete floor plugs and tighten the screws in
place.
CAUTION:
When tightening the screws in place, first tighten the screws in place ¾ of the way.
Once all screws are in place, then tighten each screw progressively, one after each other to
ensure that the floor bracket is solidly fixed into place and completely vertically aligned. The
use of a level may be required.
ensure that the floor bracket is solidly fixed into place and completely vertically aligned. The
use of a level may be required.
9. Unplug the connector block. Strip the 3 wires from the power supply cable and connect them to
the connector block provided according to the instructions below as indicated on the PCB.
Please see figure below.
Please see figure below.
Figure 5: Connector Block
System Fuse
Line
Neutral
Earth
Connector Block
CAUTION
: Fix the main power cable using the specific clip as shown in
Figure 6: Power Cable Fixing
18/50
Revision 1.0
December 2004