Advanced Control Technologies Inc. 0791-01 Manuale Utente

ZRF113 Instructions, Release 5.1 

P/D 081110

0791-01

1

The ZRF113 Isolated Contact Fixture Module is a component of the HomePro lighting control system.   Wire the 

Isolated Contact Fixture Module according to the diagram above and program it from the Wireless Controller to 

operate loads.   Inclusion of this Switch on the ZTH100 Wireless Controller menu allows remote ON/OFF control 

of load connected.  
This  Isolated Contact Fixture Module is designed to work with other Z-Wave enabled devices.  Z-Wave nodes of 

other types can be included on the network and will also act as repeaters if they support this function. 
As part of a Z-Wave network, the ZRF113 will also act as a wireless repeater to insure that commands intended 

for another device in the network are received.  This is useful when the device would otherwise be out of the radio 

range of the wireless controller. 
There are no field repairable assemblies on this unit..  If service is needed, the unit must be returned where purchased.
DANGER!  SHOCK HAZARD.  Read and understand these instructions before installing.  This device is intended 

for installation in accordance with the National Electric code and local regulations in the United States, or the 

Canadian Electrical Code and local regulations in Canada.  It is recommended that a qualified electrician perform 

this installation.
For indoor use only.  Retain instructions for future use. 

Wire this module in series with a (maximum) 20 amp load according to the diagram above. 
AS101’s are required to be

 wired to the same line (or neutral) which is also wired to the master unit as well 

as the load being controlled, and not wired to any other neutral. If multiple neutrals are tied together in one box, 

separate the neutrals to preserve the integrity of the ZRF113 circuit. See the ZTH100 Wireless Controller operating 

instructions to include this module under the command of the Wireless Controller.

Push the button on the face to configure the module to operate from the wireless controller (see ZTH100 instruc-

tions).  With the Wireless Controller, the ZRF113 can be switched ON and OFF remotely, and can be included