Advanced Control Technologies Inc. 0791-01 Manuale Utente
ZRF113 Instructions, Release 5.1
P/D 081110
HomePro
by ADVANCED CONTROL TECHNOLOGIES, INC.
0791-01
2
in groups of lights that operate at the same time (a group can also be a single module), and in scenes that set
a lighting mood.
Switch power ON and OFF with Auxiliary Switch
The ZRF113 can also be controlled from an AS101 ver.2 auxiliary switch in another location. A second AS101v2
(maximum is two) can be wired in parallel with the first to create 4-way control.
Other functions
The button on the ZRF113 also plays a role as a reset in addition to including the module in groups and scenes.
This is described in more detail in the Wireless Controller instructions.
Over-current protection
The ZRF113 is protected by an internal fuse. This internal fuse is factory serviceable only. Check your home
circuit breakers before concluding that the product must be returned to manufacturer for repair at a nominal
charge.
Button (Local Control)
The button on the ZRF113 allows the user to
•
Turn the load attached ON or OFF.
•
Include or exclude the module in the Z-Wave system:
STEP 1. Prepare the Controller to include a unit to the network by adding it to a group (method of adding
a node to the network). Refer to controller instructions.
STEP 2. The ZRF113 must be in its permanently installed location.
• To add a node: Tap the button.
• To remove a node: Tap the button 3 times, then press and hold (Ex. tap, tap, tap, hold)
• To remove a node: Tap the button 3 times, then press and hold (Ex. tap, tap, tap, hold)
STEP 3. You should see an indication on your Controller that the “DEVICE WAS INCLUDED” or “DEVICE
WAS EXCLUDED” in the network.
If attached, an AS101 ver.2 auxiliary switch can also be used to Include or Exclude the module from the Z-Wave
system. When a controller prompts you to “Send Node ID” or to “Press Button on Unit”, follow steps 1 through
3 above to satisfy those instructions.
LED indication
The LED on the ZRF113 will turn on when the load attached is ON. The LED can be user configured however
to turn ON when the load attached is OFF, if so desired. The ZRF113 will flicker its LED when it is transmitting
to any of its 4 groups. This can be changed if desired.
Remote Control
The ZRF113 will respond to BASIC and BINARY and SCENE commands that are part of the Z-Wave system.
Refer to your controller’s instructions as to whether your controller can transmit those commands.
ADVANCED OPERATION
All On/All Off
The ZRF113 supports the ALL ON/ ALL OFF commands.
The ZRF113 can be set to respond to ALL ON and ALL OFF commands 4 different ways.
Refer to your controller for information on how to set the ZRF113 to operate in the manner you desire. Some
Refer to your controller for information on how to set the ZRF113 to operate in the manner you desire. Some
controllers may be only able to set certain settings of ALL ON/ALL OFF response.
The 4 different ways the ZRF113 can be setup to respond to ALL ON and ALL OFF commands are:
The 4 different ways the ZRF113 can be setup to respond to ALL ON and ALL OFF commands are:
•
ZRF113 will not respond to ALL ON or the ALL OFF command.
•
ZRF113 will respond to ALL OFF command but will not respond to ALL ON command.
•
ZRF113 will respond to ALL ON command but will not respond to ALL OFF command.
•
ZRF113 will respond to ALL ON and the ALL OFF command.